Battery Case
To install the battery case:
1.Insert the battery case wires through the left hole in the battery case mortise and into the circuit board mortise.
2.Slide the battery case (Figure 13) into the mortise and secure with two #2 x 1⁄4" black screws.
AC/DC
Output
Headphone
Figure 14. Inserting jacks through jack plate.
4.Reinstall the nuts and washers removed in Step 1, using an 11 and 13mm wrench, then fasten the jack plate to the guitar with the two #3 x 1⁄2" silver screws (Figure 15).
Figure 13. Installing battery case.
Headphone, AC/DC & Output Jacks
To install the headphone, AC/DC, and output jacks:
1.Remove the hex huts and washers from the headphone, AC/DC, and output jacks.
2.Solder the battery wires onto the AC/DC jack as shown on the Wiring Diagram on Page 23 and the Electrical Components photos on Page 24.
3.Insert the headphone, AC/DC, and output jacks out through the hole in the side of the guitar, then through the jack plate (Figure 14).
Figure 15. Securing jack plate.
Model H7582 Junior Electric Guitar Kit |
