Covers |
| ||
Components Needed | Qty | ||
Guitar | ⁄4" | 1 | |
Black Screws #2 x | 1 | 8 | |
|
|
| |
Circuit Board Cover | ........................................... | 1 | |
Speaker Cover |
| 1 | |
To install the speaker and circuit board cov- | |||
ers: |
|
|
|
1.Place the circuit board and the speaker cov- ers over the mounting holes (Figure 19) and secure each cover with four #2 x 1⁄4" black screws.
Bridge |
|
Components Needed | Qty |
Guitar | 1 |
Bridge | 1 |
Silver Screws #4 x 3⁄4" | 5 |
For the guitar to be grounded correctly, a section of exposed grounding wire must contact the bot- tom of the bridge.
To attach the bridge to the guitar body:
1.Make sure the end of the grounding wire fits snugly in the hole shown in Figure 20. The exposed wires should protrude past the hole enough to contact the bridge.
2.Secure the wire insulation in the hole with rubber cement, leaving the end exposed.
3.Align the mounting holes on the guitar and bridge (Figure 20) and secure over the ground wire with five #4 x 3⁄4" silver screws.
Figure 19. Covers secured.
Exposed |
|
Section | Ground |
| Wire |
Figure 20. Bridge placement.
Model H7582 Junior Electric Guitar Kit |
