Grizzly H8259 owner manual Assembly Test Run, To assemble the lathe, To test run the machine

Assembly Test Run

Before use, the tool rest must be moved out of its shipping position and the quill handwheel knob must be attached.

To assemble the lathe:

1.Loosen the release lever and rotate the tool rest base away from the lathe bed.

2.Loosen the tool rest lock handle and rotate the tool rest so that it is positioned parallel to the lathe bed (Figure 6).

3.Tighten the tool rest lock handle.

Tool Rest Tool Rest

Lock Handle

	Release
Tool Rest
	Lever
Base

Figure 6. Tool rest positioned.

4.	Secure	the	crank	to	the quill	handwheel
	(Figure 7).
					Quill
					Handwheel
	Crank

Figure 7. Quill handwheel crank installed.

-12-

Once the assembly is complete, test run your machine to make sure it runs properly and is ready for regular operation.

The test run consists of verifying the following:

1)The motor powers up and runs correctly.

2)The safety paddle switch works correctly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review the Troubleshooting on Page 26. If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

To test run the machine:

1.Make sure that you have read the safety instructions at the beginning of this manual and that the machine is setup properly.

2.Connect the machine to the power source.

3.Turn the machine ON. Make sure that your hand stays poised over the switch in case you need to quickly turn the machine OFF.

—When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.

—Investigate and correct strange or unusual noises or vibrations before operating the machine further. Always disconnect the machine from power before investigating or correcting potential problems.

4.Turn the machine OFF.

5.Remove the safety key and attempt to turn the machine ON.

—If the machine starts, stop it and disconnect it from power. The switch disabling feature is not working. This safety feature must work properly before proceeding. Call Tech Support for help.

—If the machine does not start, the switch disabling feature is working.

H8259 10" x 18" Benchtop Lathe