3.Open the side and rear access covers (Figure 10).
| Rear Access Cover |
| Side Access |
Side Access | Cover Knob |
| |
Cover |
|
Figure 10. Side and rear access covers.
4.Locate the desired speed on the speed chart on the rear of the lathe bed, and move the belt to the desired grooves on the motor and spindle pulleys.
For Example: As indicated in the speed chart, belt position B creates 1960 RPM (Figure 11).
� | �������� | ��� | |
� | ���� | ||
� | |||
� | ���� | ||
� | |||
� | ���� | ||
� � | |||
| � | ��� | |
| � | ��� |
������������
Figure 11. H8259 Spindle speeds.
5.Move the belt tension lever down, adjusting tension so that ½" of belt deflection is mea- sured as shown in Figure 12, then tighten belt tension lever screw.
������
����������
������
Figure 12. Belt deflection.
6.Tighten the motor mount screw.
7.Replace the rear and side covers and tighten the cover knobs.
H8259 10" x 18" Benchtop Lathe |
