Figure 12a.
Dust Hood |
| Motor Cover |
|
|
|
|
|
|
The Model G1023Z Series comes with a 4" dust hood and a cleanout door.
To mount the dust hood and cleanout door:
1.Mount the cleanout door into the square hole on the lower left side of the saw base.
2.Using (4) #8 x 3Ú8" Self Tapping Screws and #8 Flat Washer, screw the dust hood to the cleanout door.
3.Be sure to orient the dust hood so the 4" flange is on the lower half of the dust hood when installed as shown in Figure 11.
Cleanout Door
Self Tapping
Screw
Dust Hood
Figure 11. Installing dust hood.
The Model G1023Z Series motor cover is designed to increase the efficiency of dust collec- tion. The motor cover is packaged amd shipped in a separate box. It is held shut by a 1Ú4"-20 x 1Ú2" knob bolt as shown in
Motor Cover
Knob Bolt
Figure 12a. Installed motor cover.
G1023Z Series |
