SECTION 4: OPERATION
Operation Safety
!Disconnect power to the machine when perform-
ing any maintenance, assembly or adjust- ments. Failure to do this may result in serious personal injury.
Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.
Wear safety glasses dur- ing the entire operations process. Failure to com- ply may result in serious personal injury.
Always wear a respi- rator when operating your dust collector. This machine circulates saw- dust dust which may cause allergic reactions or respiratory problems.
Test Run
Once assembly is complete and adjustments are done to your satisfaction, you are ready to test run the machine.
Turn on the power supply at the main panel. Turn the dust collector ON. Make sure that your finger is poised on the toggle switch just in case there is a problem. The dust collector should run smoothly, with little or no vibration or rubbing noises. Strange or unnatural noises should be investigated and corrected before operating the machine further.
If you cannot easily locate the source of an unusual noise or vibration, contact our service department for help.
General
Operating your Model G8027 is simple and straightforward. Move the dust collector to the machine location, connect the duct, connect the ducting ground, and you are ready to begin.
DO NOT use the dust collector for any other purpose besides collecting dust from connected woodworking machines. A dust collector should NEVER be used as an air cleaner. For safest use, wear a respirator and use an air cleaner in addition to the dust collector.
G8027 1 HP Dust Collector |
