Collection and
Filtration Bags
Components and Hardware Needed: | Qty |
Collection Bag | 1 |
Filtration Bag | 1 |
Bag Clamps | 2 |
To install the collection bag:
1.Place the collection bag over the bottom edge of the collector and secure the bag clamp as shown in Figure 12.
Clamp | Cleated Tips of Belt |
Wide Foam Strip |
|
Figure 12. Securing collection bag onto collec-
tor.
2.If belts are not already installed on the col- lection and filtration bags, thread the cleated end of each belt through the left hole and out the right hole of each bag. Make sure cleated tips face out.
3.Bag clamp springs should be located between the belt and latch (Figure 13); if not, the bag clamp will not work. Adjust the springs if needed.
Springs
Latch
Belt
Figure 13. Correct bag clamp spring position.
To install the filtration bag:
1.Hook the top of the filtration bag onto the upper bag support rod, slip the filtration bag over the top of the collector, and secure the bag clamp. The dust collector should look similar to Figure 14 when fully assembled.
Figure 14. Filtration and collection bags
installed.
G8027 1 HP Dust Collector |
