Base and Supports
Components and Hardware Needed: | Qty |
Motor/Impeller Housing | 1 |
Collector | 1 |
Base | 1 |
Rubber Gasket | 1 |
Swivel Casters | 4 |
Collection Bag Support Rods | 2 |
Upper Bag Support Rod | 1 |
Impeller Housing Support | 1 |
Hex Bolts M6-1 x 15 | 6 |
Hex Bolts M8-1.25 x 15 | 8 |
Hex Nuts M5-.8 | 18 |
Hex Nuts M8-1.25 | 4 |
Flat Washers 5mm | 22 |
Flat Washers 8mm | 12 |
Phillips Head Screws M5-.8 x 15 | 6 |
Phillips Head Screws M5-.8 x 10 | 16 |
Phillips Head Screws M4-.7 x 8 | 2 |
To assemble the dust collector base: | |
1.Make sure the dust collector motor is unplugged!
2.Install the swivel casters onto the base with sixteen M5-.8 x 10 Phillips head screws, nuts, and flat washers (see Figure 5).
Figure 5. Installing casters.
-12-
3.Place the base right side up and install the collector support (Figure 6) using four M8- 1.25 x 15 hex bolts and four flat washers.
Figure 6. Installing collector support.
4.Place the motor/impeller housing onto the collector support plate and fasten with four M8-1.25 x 15 hex bolts, four hex nuts, and eight flat washers as shown in Figure 7.
Figure 7. Installing motor/impeller housing on
collector support.
G8027 1 HP Dust Collector
