5.Install the rubber gasket onto the motor/ impeller housing opening.

6.Install the collector onto the motor/impeller housing with six M6-1 x 15 hex bolts, as shown in Figure 8.

Collector

Motor/Impeller Housing

Figure 8. Installing collector onto motor/impeller

housing.

7.Secure the two collection bag support rods to the base plate with four M5-.8 x 15 Phillip head screws and four flat washers, and to the collector using two M5-.8 x 15 Phillip head screws, two flat washers, and two hex nuts as shown in Figure 9.

Figure 9. Securing collection bag support rods.

G8027 1 HP Dust Collector

8.Install the upper bag support onto the collec- tor, as shown in Figure 10, using two M4-.7 x 8 Phillips head screws.

Figure 10. Installing upper bag support.

Collector Support

Bolts

1.Adjust the two hex bolts located on the col- lector support plate (Figure 11) so the bolt heads press against the motor/impeller hous- ing.

2.Tighten the hex nuts against the support

Figure 11. Adjusting collector support plate

bolts.

-13-

Page 15
Image 15
Grizzly Model G8027 instruction manual Collector Support Bolts, Installing upper bag support