INSTALLATION
UNIT ASSEMBLY PRIOR TO INSTALLATION
TOP FLUE COLLAR INSTALLATION
Note: This conversion must be done prior to the unit being placed in position.
The unit comes equipped as a rear vent unit. These instructions are to be used, only if the unit is going to be top vented.
Top Collar Assembly Kit
1Intake Collar Assembly with Gasket
1Intake Collar Plate with Gasket
1Top/Rear Exhaust Assembly with Gasket
1Heat Deflector
1Baffle Plate
291/4" x 1/2" Screws (4 spares)
1 | Restrictor |
1 | Intake Collar Gasket (spare) |
1 | Exhaust Assembly Gasket (spare) |
Exhaust Assembly | Intake Collar Plate | Intake Collar Assembly |
w/ gasket | w/gasket | w/gasket |
1. Remove the door assembly by releasing the adjustable latches and lifting up off the door frame assembly.
Adjustable Tension
Latch location
2)From inside the firebox, remove the top heat deflector by removing 2 - 1/4" x 1/2" screws.
Diagram 2
3)From inside the firebox, remove the baffle plate by removing 4 - 1/4"
x1/2 " screws. See Diagram 3
Baffle Plate | Diagram 3 |
|
Diagram 1
4)From the inside of the firebox, remove the exhaust assembly by removing the 8 - 1/4" x 1/2" screws. See Diagram 4.
Diagram 4
14 | Regency Bellavista™ B36X Gas Fireplace |