INSTALLATION
5)From the outside rear of the firebox, remove the intake collar assembly. Remove the 4 - 1/4" x 1/2" screws. See Diagram 5.
8)From the outside top of the firebox, install the intake collar assembly. Secure with 4 - 1/4" x 1/2" screws. Ensure all screws are tight, but do not over tighten. All 4 screws must be used.
Exhaust
Assembly
Intake Collar
Assembly
Diagram 5
6) From the outside top of the firebox, remove the intake collar plate |
by removing the 4 - 1/4" x 1/2 " screws. See Diagram 6. |
Diagram 9
Exhaust
Assembly
Intake Collar
Assembly
Diagram 6
9)From the outside rear of the firebox, install the intake collar plate with 4 - 1/4" x 1/2" screws. Ensure all screws are tight, but do not over tighten. All 4 screws must be used.
Diagram 10
Before proceeding to Step 7, inspect condition of all gaskets.
DO NOT install parts with damaged gaskets. Replace if necessary with spare gaskets supplied.
10)From inside the firebox,
7)From the inside of the firebox, place the exhaust assembly into position as shown in Diagram 7 and secure with 8 - 1/4" x 1/2" screws (Diagram 8). Ensure all screws are tight, but do not over tighten.
All 8 screws must be used.
Diagram 7
Diagram 8
VENTING
INTRODUCTION
The B36X uses the "balanced flue" technology
outer liner draws outside combustion air into the combustion chamber thereby eliminating the need to use heated room air for combustion and losing warm room air up the chimney.
Note: These flue pipes must not be connected to any other appliance.
The gas appliance and vent system must be vented directly to the outside of the building, and never be attached to a chimney serving a separate solid fuel or gas burning appliance. Each direct vent gas appliance must use it's own separate vent system. Common vent systems are prohibited.
Regency Bellavista™ B36X Gas Fireplace | 15 |