Regency B36X Installation, Optional WALL THERMOSTAT, Optional REMOTE CONTROL, Wall Switch, 14 GA

Models: B36X

1 64
Download 64 pages 45.68 Kb
Page 48
Image 48
Optional

INSTALLATION

Optional

WALL THERMOSTAT

A wall thermostat may be installed if desired, connect the wires as per the wiring diagram. Use table below to determine the maximum wire length.

Note: Preferable if the thermostat is installed on an interior wall.

Regency® offers an optional programmable thermostat but any 250-750 millivolt rated non- anticipator type thermostat that is CSA, ULC or UL approved may be used.

CAUTION

Do not wire millivolt wall thermostat wires to 120V wire.

Thermostat Wire Table

Recommended Maximum Lead Length

(Two-Wire) When Using Wall

Thermostat (CP-2 System)

Wire SizeMax. Length

 

 

14 GA.50 Ft.

 

 

16 GA.32 Ft.

 

 

18 GA.20 Ft.

 

 

20 GA.12 Ft.

 

 

22 GA.9 Ft.

 

 

Optional

REMOTE CONTROL

Regency offers 3 different remote control options which are Proflame GT, GTM and GTMF models. See next page of all available features of each version.

Use the Regency® Remote Control Kit approved for this unit. Use of other systems may void your warranty.

The remote control kit comes with a hand held transmitter, a receiver and a wall mounting plate.

1)Choose a convenient location on the wall to install the receiver and the receptacle box (protection from extreme heat is very important). Run wires from the fireplace to that location. Use Thermostat Wire Table.

CAUTION

Do not wire millivolt remote control wires to 120V wire.

2)See optional remote control instruction manual for detailed instructions.

WALL SWITCH

(INCLUDED)

1)Run the supplied 10' of wire through the right or left side gas inlet opening. Be careful not to damage wire.

Note: We recommend a maximum of 10' of wire but if you wish to go with a longer run, use the Thermostat Wire Table.

2)Connect the wire to the wall switch and install into the receptacle box*. Also attach wires to the valve as shown below.

*The receptable box (gang box) is not supplied with the unit. Must be purchased separately.

CAUTION

Do not wire millivolt

wall switch wire

to 120V wire.

48

Regency Bellavista™ B36X Gas Fireplace

Page 48
Image 48
Regency B36X Installation, Optional WALL THERMOSTAT, Optional REMOTE CONTROL, Wall Switch, Included, to 120V wire, 14 GA