|
|
|
| INSTALLATION | ||
|
|
|
|
|
| |
|
| OPTIONAL STAINLESS STEEL / BLACK ENAMEL | ||||
|
| PANEL INSTALLATION | ||||
|
|
|
|
| ||
|
| Before installation, panels must be handled and cleaned as per instructions noted below: |
|
| ||
|
|
|
|
|
| |
|
| Stainless Steel Panels |
| Black Enamel Panels |
| |
| • Stainless panels must be inspected for scratches and dimples prior | • Black Enamel panels must be inspected for scratches and dimples |
|
| ||
| to installation. All claims to be recorded at this time. | prior to installation. All claims to be recorded at this time. |
| |||
| Claims for damage after installation will not receive consideration. | Claims for damage after installation will not receive consideration. |
| |||
|
|
|
|
|
| |
| • To protect the finish during installation and handling - cotton gloves |
|
|
|
| |
| MUST be worn at all times while handling the panels (even when |
|
|
|
| |
| removing protective coating). |
|
|
|
| |
|
|
|
| |||
| •Stainless panels will discolor a little during normal operation. | • Black Enamel panels will discolor a little during normal operation. This |
|
| ||
| This is normal and should not be considered a defect. | is normal and should not be considered a defect. |
| |||
|
|
|
|
|
|
|
| * | All hand and finger marks MUST be cleaned off with a soft cloth and | * | All hand and finger marks MUST be cleaned off with a soft cloth. Use |
|
|
| a stainless steel cleaner. Most stainless steel cleaners leave a film/ | an ammonia based cleaner (ie. glass cleaner) to remove any fingerprints |
| |||
| residue on the surface of the panels. Use an ammonia based cleaner | before applying heat to the unit. |
| |||
| (ie. glass cleaner) to remove this film before applying heat to the unit. | Failure to do this will result in burn stains on panels which you |
| |||
| Failure to do this will result in burn stains on panels which you | will be unable to remove. Not protected by product warranty. |
| |||
| will be unable to remove. Not protected by product warranty. |
|
|
|
| |
STAINLESS STEEL PANEL INSTALLATION
Note: Panels must be installed prior to the installation of the log set and vermiculite.
| TOP | |
LEFT | BACK | |
RIGHT | ||
|
Diagram 4
Diagram 1
1)Remove the heat deflector by removing the 2 screws securing the heat deflector to the top of the firebox (see Diagram 2).
3)Slide back panel in over burner - be careful not to scratch panel on back log tray, burner, or top panel when positioning.
Heat defl ector | Diagram 2 |
2)Loosen the 2 baffle screws - position the top panel inside the firebox shown in Diagram 4. Slide slots of top panel into position under loosened screws, retighten the screws.
Slots on Top Panel
Diagram 5
Diagram 3
Regency Bellavista™ B36X Gas Fireplace | 43 |
