CIRCUIT REQUIREMENTS

110V Operation

Amperage Draw

The Model T10097 motor draws the follow- ing amps under maximum load:

Motor Draw

1.2 Amps

Minimum Circuit Requirement

We recommend connecting your machine to a dedicated and grounded circuit that is rated for the amperage given below. Never replace a circuit breaker on an existing circuit with one of higher amperage with- out consulting a qualified electrician to ensure compliance with wiring codes. If you are unsure about the wiring codes in your area or you plan to connect your machine to a shared circuit, consult a qualified electrician.

110V Circuit.................................. 15 Amps

Plug/Receptacle Type

Included Plug Type...................NEMA 5-15

<gdjcY^c\Egdc\^h Adc\Zhid[i]ZI]gZZ Egdc\h

8jggZci 8Vggn^c\Egdc\h <gdjcYZY

DjiaZi

Figure 1. 5-15 Plug & receptacle.

-8-

Electrocution or fire could result if machine is not grounded cor- rectly or if electrical configuration does not comply with local and state codes. Ensure compliance by check- ing with a qualified electrician!

This machine must have a ground prong in the plug to help ensure that it is grounded. DO NOT remove ­ground prong from plug to fit into a two-pronged outlet! If the plug will not fit the outlet, have the proper outlet installed by a qualified electri- cian.

Extension Cords

We do not recommend the use of exten- sion cords, but if you find it absolutely necessary:

Use at least a 14 gauge cord that does not exceed 50 feet in length!

The extension cord must also contain a ground wire and plug pin.

A qualified electrician MUST size cords over 50 feet long to prevent motor dam- age.

Model T10097 Wet Grinder

Page 8
Image 8
Grizzly T10097 Circuit Requirements, 110V Operation, Amperage Draw, Minimum Circuit Requirement, Plug/Receptacle Type