Grizzly T25100 owner manual Power Supply, 120V, 60 Hz, Phase, Amps

SECTION 2: POWER SUPPLY

Availability

Before using the Model T25100, consider the availability and proximity of the required power supply circuit. If an existing circuit does not meet the requirements for this tool, a new circuit must be installed. To minimize the risk of electrocu- tion, fire, or tool damage, installation work and electrical wiring must be done by an electrician or qualified service personnel in accordance with all applicable codes and standards.

Electrocution, fire, or system damage may occur if system is not correctly grounded and connected to the power supply.

120V Circuit Requirements

This tool is prewired to operate on a power supply circuit that has a verified ground and meets the following requirements:

Nominal Voltage	120V
Cycle	60 Hz
Phase	Single-Phase
Power Supply Circuit	15 Amps

Model T25100 (Mfg. Since 8/12)

A power supply circuit includes all electrical sys- tems between the breaker box or fuse panel in the building and the T25100 control box. The power supply circuit used for this tool must be sized to safely handle the current drawn from the tool for an extended period of time. (If this machine is connected to a circuit protected by fuses, use a time delay fuse marked D.)

Note: The circuit requirements listed in this manual apply to a dedicated circuit—where only one tool or machine will be running at a time. If this tool will be connected to a shared circuit where multiple tools or machines will be running at the same time, consult a qualified electrician to ensure that the circuit is properly sized for safe operation.

for your own safety and protection of property, consult an electrician if you are unsure about wiring practices or electrical codes in your area.

-7-