Grundig 26 VLE 8100 BG settings for motorised antennas (DiseqC 1.2)

ENGLISH
60
settings for motorised antennas
(DiseqC 1.2)
Your television set supports motorised satellite
systems in compliance with DiSEqC 1.2. This
function allows the satellite antenna to be oper-
ated via the television set.
1 Open the menu with »menu«.
2 Select the line »SOURCE SETUP« with »
v «
or »
Λ « and press »oK« to confirm.
– The »SOURCE SETUP« menu appears.
3 Select the line »DiSEqC 1.2« with »
v «
or »
Λ «. Select the option »On« with »
<
«
or »
>
«
– The line »User Mode« is active.
note:
7
Additional operations are explained in the
following sections.
speCiAl settinGs ----------------------------------------------------------------------------------------------------------
user mode
You can adjust the alignment of the satellite an-
tenna to each individual satellite. These settings
will be saved so that the antenna can later be
easily guided to each saved alignment.
1 Select the line »User mode« with »
v «
or »
Λ « and press »oK« to confirm.
– The »USER MODE« menu appears.
2 Select the preferred option with »
v «
or »
Λ «.
– »Satellite«: »Press oK«, select a satellite
with »
<
«, »
>
«, » v « or » Λ « and press
»oK« to confirm.
– »Transponder«: »Press oK«, select the
transponder from which the signal is being
received with »
<
«, »
>
«, » v « or » Λ « and
press »oK« to confirm.
– »Moving Mode«: Use »
<
« or »
>
« to select
the option »Discrete« or »Continuous«.
– »Discrete«: Moves the antenna in defined
steps to the west and the east.
– »Continuous«: Moves the antenna to the
west or east continuously.
– »Step Size«: Use »
<
« or »
>
« to select the
number of steps with which the antenna
should turn. »Step Size« is only active
when the »Transport Mode« was set to
»Discrete«.
– »Move Motor«: Aligns the antenna with
the selected satellite. Use »
<
« to align it to
»West«, use »
>
« to align it to »East«.
– »Go To Stored Position«: Aligns the antenna
to a saved satellite position. Up to 50 posi-
tions can be saved. »Press oK« and then
select the saved position with »
<
« or »
>
«.
Press »« (green) to confirm – the anten-
na will be aligned with the saved position.
– »Store Stored Position«: The current anten-
na alignment is saved.
3 Press »menu« to end the setting.