Grundig 32 VLD 8130 SL Searching for television channels from the cable provider manu- ally, Searching for digital terrestrial TV channels automatically

71
ENGLISH
SPECIAL SETTINGS ----------------------------------------------------------------------------------------------------------
Searching for television channels
from the cable provider manu-
ally
1 Open the menu with »MENU«.
2 Select the line »SOURCE SETUP« with »
V «
or »
Λ « and press »OK« to confirm.
– The »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
V « or » Λ «
and press
»OK« to confirm.
Select the option »Cable« with »
<
«, »
>
«,
»
V « or » Λ « and press »OK« to confirm.
4 Select » Digital Manual Tuning« with »
V « or
»
Λ « and press »OK« to confirm.
– The menu appears.
5 Enter the four-digit frequency with »1 ... 0«
and press
»OK« to confirm.
–
The search starts after confirming, the
channels found are displayed in the »Re-
sults« menu.
6 Press »MENU« to finish the setting.
Searching for digital terrestrial
TV channels automatically
1 Open the menu with »MENU«.
2 Select the line »SOURCE SETUP« with »
V «
or »
Λ « and press »OK« to confirm.
– The »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
V «
or »
Λ « and press »OK« to confirm.
Select the option »Air« with »
<
«, »
>
«, » V « or
»
Λ « and press »OK« to confirm.
Caution:
7
The antenna power supply (line »Active
Antenna Power«) may only be switched on
if the antenna is an active indoor antenna
with a signal amplifier and it is not already
supplied with a voltage via a mains plug
(or similar supply). Otherwise you may
cause a short circuit and irreparably dam-
age your antenna.
4 Select the »Active Antenna Power« with »
V «
or »
Λ «. Switch on the antenna power supply
for the antenna with »
<
« or »
>
« (»On«).
5 Select the line »Automatic Channel Search«
with »
V « or » Λ « and press »OK« to confirm.
– The menu appears.
Exit
Back
SOURCE SETUP
AUTOMATIC CHANNEL SEARCH
20.09.2010
15:46
Start Search
Scan Type
Country
Connection Type
U.K.
Air
DTV & ATV