Grundig DR 3400 DD Connecting the antennas, Connecting the power cord, Connection And Preparation

CONNECTION AND PREPARATION_________

Connecting the antennas

S-VIDEO	SCART
FM 75 Ω	AM
RESET	LOOP

1 Plug the cable of the rooftop antenna into the FM antenna socket »FM 75Ω«.

R TV	Note:
	If no rooftop antenna is available, use the auxiliary antenna
	supplied. This antenna provides reasonably good reception of
	local FM (VHF) stations. Do not shorten the auxiliary antenna.

S-VIDEO	SCART
FM 75 Ω	AM
RESET	LOOP

2For medium wave reception, plug the cable of the supplied MW frame antenna into the »AM LOOP« socket.

Note:

In order to prevent interference, place the MW frame antenna as far as possible from the home cinema system or other sources of interference.

	Connecting the power cord
		1	Plug the power cord (»~AC IN«) into the wall socket.
	SPEAKER		Note:
SW	C RS LS	R
~AC IN			If the DVD receiver does not react when the buttons are
4-8 Ω	IMPEDANCE		pressed, this may be caused by electrostatic discharge in the
	8-16 Ω
			area. In this case pull out the mains plug and insert it into the
			socket again after a few seconds.

Inserting batteries in the remote control

1Open the battery compartment by pressing the marked area

and pulling down the cover.

2 When inserting the batteries (2 x 1.5 V, LR 06/UM 3/AA), observe the polarity marked on the battery compartment.

3 Close the battery compartment.

Note:

If the DVD receiver no longer reacts properly to remote control commands, the batteries may be flat. Be sure to remove used batteries. The manufacturer accepts no liability for damage resulting from leaking batteries.

Environmental note:

Batteries, including those which contain no heavy metal, may not be disposed of with household waste. Please dispose of used batteries in an environmentally sound manner. Find out about the legal regulations which apply in your area.

ENGLISH

15