SETTINGS ______________________________________________
Setting the loudspeaker configuration
Switching on
Language | Video | Audio | Rating |
AC3 |
| PCM |
|
DTS |
| PCM | 5ms |
MP3/WMA |
| PCM | 4ms |
Others |
| PCM | 3ms |
Pink Noise |
| Off | 2ms |
DRC |
| Off | 1ms |
CNTR CTRL |
| 0ms | 0ms |
REAR CTRL |
| 0ms |
|
1Switch on the DVD receiver from standby by pressing »9« on the remote control or »ON/OFF« on the device.
Setting the distance to the listening position
Ideally, all the speakers in a home cinema system, should be set up at equal distances from the listener. The central speaker should also be positioned in line with the front speakers. If these preconditions are met, you do not need to set a time delay for the sound, because the default setting is »0ms«.
However, central and front loudspeakers are often set up closer to the listener. In this case, the sound must be electronically delayed by a fraction of a second. This is done using the sound time delay func- tion.
If the central speaker is no more than 50 cm from the line between the front speakers, the setting is not necessary. If the distance is greater, you must find out the difference between the distances from the listener to the front speakers and from the listener to the central speaker. Enter the travel time of the sound in milliseconds (ms) (»0ms« to »5ms«). One metre roughly corresponds to 3 milli- seconds.
When using surround speakers, you must also find out the differ- ence between the distances from the listener to the front speakers and from the listener to the surround speakers. Enter the travel time of the sound from »0ms«, »3ms« to »12ms«, »15ms«. One metre roughly corresponds to 3 milliseconds.
1Select the »Audio« menu item with »a« or »s« and press »OK« to confirm.
2Select »CNTR CTRL« with »A« or »S« and press »OK« to confirm.
3In the third column, press »A« or »S« to make the setting and press »OK« to confirm.
4Select »REAR CTRL« with »A« or »S« and press »OK« to confirm.
5In the third column, press »A« or »S« to make the setting and press »OK« to confirm.
Checking the volume with a test tone
A test tone can be created for each connected speaker to check the volume level. »Off« is the default value.
1Select the »Sound« menu item with »a« or »s« and press »OK« to confirm.
ENGLISH
19