Grundig STR 400 AP manual Remote Control Functions

Remote Control Functions

Direct Programme Selection

Use the numeric buttons 0…9to directly select the desi- red programme (position).

If you enter more than one digit within approx. 3 seconds, you can call up 2- or 3-digit programme positions.

If no second or third entry is made within this time, the entry cursor jumps to the units position.

You can select 199 programme positions for TV and radio each.

Further functions of the numeric buttons are explained in chapter "Buttons on the Remote Control Handset".

Radio/TV Switching

Use the 0or ¢RADIO button to switch between TV and radio mode.

In radio mode, the picture screen remains dark and an “R“ appears after the station name in the display. When swit- ching, the display indicates for approx. 2 seconds “RADIO“ or “TV“.

] Programme Select Buttons

Step-by-step programme selection is effected with the ] buttons. Holding down these buttons automatically selects the programme positions at high speed. Inactive pro- gramme positions are skipped.

x c Buttons

In the Timer menu (see chapter "Timer Menue"), you can select one of the 4 Timer positions with the x cbuttons.

After pressing the ¢F button, you can control the motor for positioning the aerial by pressing the x cbuttons.

If you press and hold down the ¢TV button, you can set the

SAT

volume of your TV set with the x cbuttons.

bStandby

With the bbutton, the receiver is switched to standby. The display indicates "￿". LNC, switching- and AV voltages are switched off.

When in standby, pressing one of the numeric buttons 0…9 switches on the corresponding programme. When using the ] buttons, the receiver switches to the last selected TV programme (Last Station Memory).

¢TV Button

When using a suited TV receiver, the ¢TV button allows you to toggle between satellite and terrestrial reception.

.Button

Pressing the . button opens the Timer menu (see chapter "Timer Menu").

A further pressure on the .button closes the Timer menu.

OButton

Pressing the Obutton indicates for approx. 3 seconds the satellite position, e.g., "10° EAST".

In addition, this button is used for a variety of other functions (e.g., storing the Timer programme in memory, see chapter "Timer Menu").

Switching the Remote Control Level

So that you can independently control two SAT receivers being operated at a time (e.g., one for TV reception and the other for video recording), it is possible to switch the remote control level.

When switching the receiver on while holding down the

¢P/F button on the receiver, the current level "REMOTE 1 "

respectively "REMOTE 2" is indicated for approx. 3 seconds. At the factory, level 1 (Remote 1) has been preset. When holding down the ¢P/F button a longer time when switching on, the receiver will switch to the other level.

Through simultaneously pressing the -(8) button on the remote control handset and one of its other command but- tons, you can switch to the second command level of the remote control so that you can control a second receiver independently of the first one.

￿26