The MODE Menu
Clearing the child lock
Call up the "CODE" menu function and enter your personal code number (2537 in the above example). In this case, the entry is visible. Press the O button and the child lock is cleared.
The display indicates for approx. 3 seconds:
TIMER o p ü +
I99 CODEXCLR STEREO
SIGNAL IIIIIIIIIIIII
The receiver is unlocked and the security code cleared.
Remember your personal code number!
If you should forget your personal code number, the key on the last page (cover) will help you. With this combination of button pressures, you will unlock the receiver and clear the code number.
DISPLAY – Display Brightness
You can adjust the display brightness with the ¢</> but- tons. When the limits of the control range are reached, the display indicates for approx. 3 seconds "MINIMUM" and "MAXIMUM" , respectively.
ACTIVE/INACTIVE Programme Position
At the factory, the receiver has been preprogrammed for all satellite stations, including those with coded ("scrambled") programmes.
It is possible to deactivate programme positions with the
¢</> buttons. When in programme mode, inactive pro- gramme positions will be skipped when they are selected
with the ] buttons on the remote control handset. Inactive programme positions can be called up by entering their number directly with the numeric buttons or with the
¢</> buttons on the receiver.
With this menu option, inactive programme positions can be reactivated in the same way.
Datalink – Data Transmission
Datalink – Data Transmission
All memory data can be transmitted via the VCR socket wQ from a transmitting to a receiving Sat receiver.
Follow these steps:
Switch off both units and connect them with a phono (Cinch) cable (sockets wQ).
Switch on the receiving unit.
On the transmitting unit, hold down the ¢> button and switch on. Now, the unit sends the programme data to the receiving unit. While transmitting, the display indicates "SEND" (send data). If the receiving unit recognizes the transmitted data, the display of the receiving unit changes the programme number indication to "RECEIVE" (receive data).
Transmission takes approx. 3 minutes. If transmission was succesful, the display of both units will indicate "I " for pro- gramme position 1.
If an error should occur during transmission, the message "ERROR" appears in the display of the receiving unit. In this case, data transmission must be repeated.
25
