INSTALLATION
22 PNEG-1521 Commercial Direct Gear Drive Bin Sweep Auger
E. With the Rack & Pinion fully extended towards
the bin wall, attach the Half Band with six
(6) 5/16" x 1-½” Hex bolts, flat washers, and
Serrated Flange nuts.
F. Slide the ¾” Wrenches over the shafts on the
Rack & Pinion, making sure the collar faces the
gears. Fasten the Wrenches with the two
(2) 3/8" x ¾” Flange bolts and flat washers.
8. RACK & PINION INSTALLATION(Cont.)
On 36’ diameter bins, install the Rack & Pinion using the steps above, noting
that there is no Outside Intermediate Control Rod to attach to, and only one
Rack to operate the Center and Intermediate Wells.
5/16” Serrated Flange Nuts
Flat Washers
Half Band
3/8” x 3/4”
Flange Bolts
Flat
Washers
Collar
FIG. 8-D
5/16” x 1-1/2”
Hex Bolt
FIG. 8-E
3/4” Wrenches