EN-11 Digital LED LCD Television Instruction Manual
Press theB SOURCE button to select SCART mode.
Press the
C PLAY button on the external device.

HDMI INPUT

Connect the cable from the HDMI device to the TV A
HDMI socket.
Press the
B SOURCE button to select HDMI mode.
Refer to the HDMI device user guide for how to
C
operate.

MOUNT YOUR TV ONTO THE WALL

You can mount your TV onto the wall by using a wall
bracket (not supplied). Use M4/M6 machine screws (4
pcs) to screw the TV onto the bracket (not supplied).

PREPARATION OF

YOUR REMOTE

CONTROL

BATTERY INSTALLATION

Place the remote control face down, then open the A
cover of the battery compartment.
Install two AAA batteries. (The + and - symbol of the B
battery must match with the marks on the remote).
Close the cover of the battery compartment.C

BATTERY CAUTION

Confirm there is no object between the remote control
and the remote sensor of the TV set.
Sunshine or other strong light will interfere with the
signal sent by the remote control. In this situation turn
the TV set to avoid the direct light source.
Do not put the remote control in direct heat or in a
damp place as you may damage the remote.
Please use two AAA 1.5V batteries. Do not mix battery
types. Install the batteries at the correct polarities. Do
not use rechargeable batteries. If your TV is to be stored
for a period of time, remove the batteries from the
remote control.
Getting Started

Setting up

LOCATION

You will need to place your TV near your plug socket
(so the power cable can comfortably reach) and within
reach of your aerial socket or extension lead.

CONNECTION

Insert your TV aerial lead into the Antenna input at A
the side of the TV.
About your LCD / LED LCD TV / Getting Started