Operation instruction
Timer On/Off function
Before using TIMER function, calibrate the clock first.
MODE FAN SWING
TEMP
CLOCK SET
SET | TIMER | SLEEP |
HEAT FILTER RESET
RESET
ON/OFF
1.Turn on the unit
After turning on the unit, set the desired working mode.
The LCD will show working mode.
The power indicator light on the indoor unit will light up.
2.Set of TIMER mode
Press the TIMER button to change the TIMER mode, each press the TIMER mode will change as the following
sequence:
ON |
|
| OFF |
|
| ON |
| OFF |
| Blank |
|
|
|
|
| ||||||
AM |
|
|
|
| AM |
| PM |
|
| |
| PM |
|
|
|
| |||||
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
| |||
TIMER ON | TIMER OFF | TIMER |
|
| ||||||
Then choose the timer mode as need (TIMER ON or TIMER OFF.)
At this time the* ON*or * OFF*will flash.
3.Set time
Press the time adjusting button
Each press, the set time increases 10 minutes. If depress the button, the time will increase rapidly.
Each press, the set time decreases 10 minutes. If depress the button, the time will decrease rapidly.
This LCD will show the time set, the time can be adjusted within 24h. (The minimum interval is 10 minutes).
AM stands for morning, PM stands for afternoon
4.Confirm the time
After calibration of the clock, press SET button to confirm time.
At this time, the* ON or* OFFwill not flash.
The time displayed is: at x oíclock x minutes the unit will be turned on (TIMER ON) or turned off (TIMER OFF).
5.Cancel TIMER
Press the TIMER button several times until the TIMER mode display disappears.
Hints:.
After power failure, the clock should be calibrated again.
The remote controller has memory function, when you use this function for the second time, if the time set is the same as the previous one, you just need to choose the TIMER mode then press the SET button to confirm.
11
