Operation | Timer ON/OFF Function |
|
|
Manual Operation Control panel
Remote controller
ON
TEMP
ON
HEALTH | OFF | FAN |
|
| 1 |
MODE |
|
|
SLEEP |
| SWING |
CLOCK |
| SET |
TIMER |
|
|
|
| HEAT |
RESET | LIGHT | LOCK |
ON/OFF MODE | FAN | TIMER | TEMP+ TEMP- HEALTH |
| |||
|
| TEMP |
|
Set clock correctly before starting TIMER operation
1.Unit start
After unit start, select your desired operation mode (operation mode will be displayed on LCD)
2.TIMER mode selection
Press TIMER button on the remote controller to change TIMER mode. Every time the button is pressed, display of TIMER mode changes as follows:
|
| ON |
|
|
| OFF |
|
|
|
| ON |
|
|
| OFF |
|
| blank |
|
|
|
|
|
|
| ||||||||||||||
| AM 12:00 |
| PM 12:00 | AM 12:00 |
| PM 12:00 | |||||||||||||
| TIMER ON TIMER OFF |
| TIMER | ||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Then select TIMER mode as needed (TIMER ON or TIMER OFF). Now ON or OFF will flash.
3.TIMER setting (press time adjust buttons
)
Every time the button is pressed, time increases 1 minuts. If the button is kept pressed, time changes quickly.
Every time the button is pressed, time decreases 1 minuts. If the button is kept pressed, time changes quickly.
It can be adjusted within 24 hours at will.
4.Confirm setting
After setting correct time, press SET button to confirm time. Now
ON
or
OFF
stop flashing.
The control panel will display TIMER.
5.Cancel TIMER mode
Just press TIMER button several times until TIMER mode disappears.
Hints:
After replacing batteries or if a power failure occurs, TIMER setting must be reset.
Remote controller has memory function. When you use TIMER mode next time, just press SET button after mode selection if timer setting is the same as the previous one.
Note:
After setting TIMER function, the remote controller displays TIMER time.
10
