Haier AP602AKEAA, AP482AKEAA installation manual Installation procedures Electric wiring

Installation procedures Electric wiring

Note:

Electric wiring must be done by qualified person.

The power supply connects from the outdoor unit.

The connecting cable and power cable are self-provided.

Wiring of indoor unit

Insert the cable from outside the wall hole where piping already exist.

Pull it out from front.

Loosen terminal screws and insert cable end fully into terminal block, then tighten it.

Pull the cable gently to make sure it is tight.
Replace cover after wiring.	OK	NO
Wiring of outdoor unit		terminal block
Insert the cable from inside the wall	hole	table clamp
where piping already exists.
Pull it out from front.

Loose terminal screw and insert cable end fully into terminal block, then tighten it.

Pull the cable gently to make sure it is tight. Replace cover after wiring.

AP482AKEAA AP602AKEAA

1 2 3

Y/G

Y/GR S T N 1 2 3

POWER SUPPLY: 380-400V, 3N~, 50Hz

Note:

When connecting indoor and outdoor wire, check the number on indoor and outdoor terminal blocks.Incorrect wiring may damage air conditioner's controller or cause operation failure.

26