Haier AS12SB1HRA/1U12QE6ERA, AS09SH1ERA/1U09EH1ERA, AS09SB1HRA/1U09QE6ERA operation manual Operation

Operation
Inner side of the controller
				operating power is 100W;
SMART				when the panel display “02”,
	SET TEMP. ROOM TEMP.			the operating power is
COOL
				200W, and so forth)
HEAT
FAN				21.LIGHT button
DRY				Control the lightening and
CTD	AUTO	AUTO
POWER	FAN		AUTO	extinguishing of the indoor
	SPEED
SOFT				LED display board.
ECO
				The manual of how to change
iFP	AM	TIMER ON	OFF
				the default display temp：
	PM
26				Press LIGHT button
			27	continuously for ten times, the
SMART
				display temp on display panel
25
			28	can be changed between
24			29	ambient temp and set temp.

3022.POWER / SOFT button

23	23.10
22	31 special heating set function:

10 degree heating maintaining

21

32 (valuable for RS)

20

2	Load the batteries as illustrated. 2 R-03
	batteries,resetting key(cylinder); Be sure
	that the loading is in line with the" + "/"-";

3

Load the battery,then put on the cover again.

Clock set

1 Press CLOCK button,

"AM" or "PM" flashes.

2Press “+” or “-” to set correct time.

19

33

24.HEALTH AIRFLOW

18 34

18.CODE button

Used to select CODE A or B with a press, A or B will be displayed on LCD.Please

select A without special explanation.

19.RESET button

When the remote controller appears abnormal,use a sharp pointed article to press this button to reset the controller normal.

button

25.HEALTH button

26.SWING UP/DOWN button

27.SWING LEFT/RIGHT button

28.FRESH button 29.SLEEP button 30.TIMER ON / OFF button 31.HOUR button

32.CANCEL/CONFIRM button

Used to confirm timer and clock settings.

AM

PM

SMART

Each press will increase or decrease 1min.If the button is kept pressed,time will change quickly.

3Confirm time.

After time setting is confirmed, press CONFIRM,"AM "and "PM" stop flashing,while

20.INQUIRE button	33.CLOCK button
Inquire the external	34.LOCK button
environmental temperature	If pressed, the other buttons
and the operating power of	will be disabled. Press it once
the machine. (e.g. when the	again,lock will be cancelled.

panel display “01”, the

This function unavailable on this models.

Loading of the battery

1

Remove the battery cover;

clock starts working.

Note:

The distance between the signal transmission head and the receiver hole should be within 7m without any obstacle as well. When electronic-started type fluorescent lamp or change-over wireless telephone is installed in the type fluorescent lamp or room, the receiver is apt to be disturbed in receivingthe signals, so the distance to the indoor unit should be shorter.

Full display or unclear display during operation indicates the batteries have been used up.Please change batteries.

If the remote controller can’t run normally during operation, please remove the batteries and reload several minutes later.

Hint:

Remove the batteries in case unit won’t be in usage for a long period.If there are any display after taking-out,just need to press reset key.

2