8
English
Installing the Guardrail
Follow the steps below to install the guardrail on
the worktop.
1. Place the guardrail on top of the cabinet.
2. Align all holes of the guardrail with the holes
of the cabinet.
3. Secure the guardrail to the cabinet with eight
small Phillips-Head screws.
Installing the CO2Regulator and CO2Cylinder
Follow the steps below to safely install the CO2regulator and CO2cylinder. You
must read and understand the following procedures for CO2cylinders before
installation.
Note: Your CO2cylinder is shipped empty to avoid any possible accidents during
transportation. When you purchase the first keg of beer, have your beer
distributor fill the CO2cylinder.
1. Install the CO2air line hose to the regulator by attaching one end of the red air
line hose to the hose barb connection on the
CO2regulator. Secure the hose by using one
of the two self-locking black plastic snap-on
clamps. Use pliers to snap the clamp on
tightly to ensure that there are no leaks.
2. Attach the CO2regulator to the CO2
cylinder by screwing the regulator nut onto
the cylinder valve and tightening with an
adjustable wrench.
3. Remove the nut from the retainer bolt.
Use two retainer fixing screws to secure the
retainer to the holes on the back of the
cylinder.
4. Slide the cylinder through the retainer and
place it in the cabinet. Then tighten the
retainer nut.
WARNING!CO2can be dangerous! CO2cylinders contain high-pressured gas, which
can be hazardous if handled improperly. They must be handled with care.
CO2 Cylinder
CO2
GAS
CO 2
Regulator
Connect to the CO2
Air Line
Clamp
Shut-Off
Valve
Retainer
Connect to the CO2Cylinder