Haier HSU-12HQA03/R2(DB) Vertical blade, Horizontal flap, Singal sending display, Temp display

Parts and Functions

Indoor Unit

Remote controller

9. ON/OFF button

Inlet

Inlet grille

Nano-Aquo Generator （inside）

Outlet

Air Purifying

Filter Anion

generator

(inside)

Vertical blade

(adjust left and right air flow)

Horizontal flap

(adjust up and down air flow Don't adjust it manually)

10. TIMER ON display 19 11. FAN SPEED display

LOW MED HI AUTO

12. LOCK display

13. SWING display

14. SLEEP display

	15. HEALTH display
	16. Operation mode display
28	Operation mode AUTO COOL DRY HEAT FAN
	Remote controller
	17.Singal sending display

Actual indoop unit may vary from the one shown in the manual, according to the product purchased.

Display board

Aureole TEMP display

Display mode，the aureole display different colour when setting different function

COOL: blue	HEAT: red	FAN: yellow
AUTO: white	DRY: cyan	Nano-Aquo : green

Outdoor Unit

OUTLET	CONNECTING PIPING AND ELECTRICAL WIRING
INLET	4 DRAIN HOSE

Clock set

Press CLOCK button, "AM" or "PM" flashes.

Press or to set correct time. Each press will increase or decrease 1min. If the button is kept pressed,time will change quickly. After time setting is confirmed,press SET, "AM "and "PM" stop flashing,while clock starts working.

30	18. POWER/SOFT display
31
	19. Left/right air flow display
	20. TEMP display
	21. TIMER OFF display
	22. TIMER display
1. RESET button	23. TEMP button
When the remote controller	24. FAN SPEED button
appears abnormal,use a	25. HEALTH AIRFLOW button
sharp pointed article to press	26. SWING UP/DOWN button
this button to reset the remote	27. SWING LEFT/RIGHT button
controller controller normal.	28. SET button
2.LIGHT button
	29. POWER/SOFT button
Control the lightening and
	30. LOCK button
extinguishing of the indoor
LED display board.	If pressed, the other buttons will be
3. TIMER button	disabled. Press it once again, lock
	will be cancelled.
4. CLOCK button
	31.CODE
5. SLEEP button
	Used to select CODE A or B with a
6. MODE button
	press, A or B will be displayed on LCD.
7. HOUR button	Please select A without special
8. HEALTH button	explanation.

The following functions and related displays are not available： 31

Loading of the battery

		1 Remove the battery cover;
		Load the batteries as illustrated.
2		22 R-03 batteries, resetting key
	1	(cylinder);
		3 Be sure that the loading

3is in line with the" + "/"-";

4 Load the battery,then put on the cover again.

Note:

The distance between the signal transmission head and the rece- iver hole should be within 7m without any obstacle as well.

When electronic-started type fluorescent lamp or change-over type fluorescent lamp or wireless telephone is installed in the room, the receiver is apt to be disturbed in receiving the signals,

so the distance to the indoor unit should be shorter.

Full display or unclear display during operation indicates the batteries have been used up.Please change batteries.

If the remote controller can't run normally during operation, please remove the batteries and reload several minutes later.

Hint:

Remove the batteries in case unit won't be in usage for a long period. If there are any display after taking-out, just need to press reset key.

2