Haier HSU-12HQA03/R2(DB) operation manual Timer On/Off On-Off Operation, Healthy airflow Operation

Operation

Timer On/Off On-Off Operation

Set clock correctly before starting TIMER operation. 1.After unit starts, select your desired operation mode.

2.Press TIMER button to change TIMER mode. Every time the button is pressed, display changes as follows: Remote controller:

BLANK

TIMER ON TIMER OFF TIMER ON-OFF

Then select your desired TIMER mode (TIMER ON or

TIMER OFF or TIMER ON-OFF). " "or " "will flash.

3.Press TIME+ /TIME- button to set time. It can be adjusted within 24 hours.

4.After setting correct time, press SET button to confirm

" "or" " on the remote controller stops flashing.

5.Cancel TIMER mode

Just press TIMER button several times until TIMER mode disappears.

Hints:

After replacing batteries or a power failure happens, time setting should be reset.

Remote controller possesses memory function,when use TIMER mode next time, just press SET button after mode selecting if time setting is the same as previous one. According to the Time setting sequence of TIMER ON or

TIMER OFF, either Start-Stop or Stop-Start can be achieved.

Healthy airflow Operation

1.Press ON/OFF to starting

Setting the comfort work conditions.

2.The setting of healthy airflow function

1).Press the button of healthy airflow, appears on the

display. Horizontal airflow sending. Avoid the airflow blows direct to the body.

2).Press the button of healthy airflow again, appears on the display. Downward airflow sending. Avoid the airflow blows direct to the body.

3.The cancel of the healthy airflow function

Press the button of healthy airflow again, the unit goes on working under the condition before the setting of healthy

airflow function.

Notice: Do not direct the flap by hand. Otherwise, the

grille will run incorrectly. If the grille is not run correctly, stop

for a minute and then start, adjusting by remote controller.

Note:

1.After setting the healthy airflow function, the position grill is fixed.

2.In heating, it is better to select the mode. 3.In cooling, it is better to select the mode.

4.In cooling and dry, using the air conditioner for a long time under the high air humidity, condensate water may occur at the grille .

5