OPERATION | GB |
|
|
OPERATION | GB |
|
|
Colour code
L=exterior live wires,usually coloured black .
The colour is usually white.
Beware of the correct
E=earthing wire. The colour is green .
120V~60Hz
N 
L
E
How to use surface burners
Choice of cookware
Mind that the diameter of a pan base is always larger than the burner flame crown, and that the pan itself is covered. The recommended pan diameter is around 2.5 to 3 times larger than the burner diameter, that is, for:
An auxiliary burner – a pan with a diameter of 90 to 150 mm,
A medium burner – a pan with a diameter of 160 to 220 mm,
A large burner – a pan with a diameter of 200 to 240 mm, and the pan height should not be greater than its diameter.
Ignition without an ignitor
Light a match.
Press in the knob to the end and turn it left to the “large flame” position
Ignite gas with a match.
Set required flame size (e.g.
“economical” 
)
Switch off the burner afte r finishing cooking, turning the knob right (to the off position
).
Push-button ignition
| Press the spark ignition push |
| marked with |
| Press in the knob to the end and turn |
Caution!
In cooker models equipped with a surface burner safety valve, hold the knob pressed down to the end when igniting for 10 seconds at the “large flame” position to activate the safety device.
If the ignition device is out of order, either due to power failure or humid ignition device, use a match or a lighter to ignite the gas.
Keep the button pressed for approximately 10 second after ignition to stabilize the flame.
If you failed to ignite the burner after 15 seconds. Shut the burner off and wait for at least one minute before the next attempt.
Before first use
Remove packaging elements,
Gently (slowly) remove labels from the oven door, trying not to break the glue tape. If any visible trace is left on the glass, warm up the oven chamber (see below), spray the
Empty the drawer, clean off factory preservatives from the oven chamber,
Take out and wash the oven fittings with warm water and a little
Switch on the ventilation in the room or open a window,
Heat the oven (to atemper ature of
250 for approximately 30 min.), remove any stains and wash carefully.
When handling the cooker, follow the safety instructions carefully.
The oven chamber should only be washed with water and a small amount of
WRONGRIGHT
Gas burner control knobs
Postition
burner"switched off"
Position
"large flame"
Position
"economical flame"
it left to the “large flame” position |
Hold down until gas has lit |
Set the required flame size (e.g. |
“economical” ) |
Switch off the burner after finishing |
cooking, turning the knob right (to the |
off position ). |
Knob ignition
Press in the knob to the end and turn it left to the “large flame” position
Hold until gas is lit
After the flame is lighted release the pressure on the knob and set a required flame size.
Selection of the approprite flame
A correctly adjusted burner has a light blue flame with a clearly visible internal cone. Selection of flame size depends on the position of the burner knob which has been set:
Large flame
Small flame (“economical flame”) 
Burner switched off (gas supply is cut
off)
Depending on requirements, flame size can be set in a continuous manner.
WRONGRIGHT
36
37
