English
7.Connecting the water line to the “shut off” valve:.
Put the tightened nut over the copper or plastic water line,.
then the compression fitting, and insert the copper (or. plastic) end inside the “shut off” valve. Make sure the. pipe end seats all the way inside the valve. Tighten. (but don’t
specified in 248CMR of Massachusetts Federal Piping . Standard.
Massachusetts and is forbidden. Please consult a . licensed plumber if you are unsure of the assembly.
8. Clear the water line supply.
Turn on the main water supply until the water in the pipe . becomes clear and clean. Turn off the water valve after .
having used water for about 30 seconds – 1 minute. 9. Connect the water supply line to the refrigerator.
Note: Before connecting the water line to the refrigerator, make sure the water line is not draped over the power cord to the refrigerator or power outlet..
.
(1) Tighten the water supply line at the fridge water. valve by sliding the nut over the water line end.
(2) Then, as shown in the figure, connect the end. side of the water supply line to the water valve;. tighten the water supply line nut with a crescent. wrench.
Note: Please make sure that the 1/4" water tube is fully inserted into the water valve prior to tightening. Open the water supply valve and check for leaks, before positioning the unit in place.
10
