English
PREPARATION BEFORE FIRST OPERATION
Before connecting the unit to the power source, Let it stand upright for approximately 12 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
The water dispenser is
1.Do NOT plug in the water dispenser.
2.Check and make sure the drain cap on the back of the water dispenser is firmly closed.
3.Fill water tank with tap water full to capacity, wait 5 minutes until water settles.
4.Activate the child safety button and press the hot water lever until water starts to come out, then stop.
5.Plug the dispenser into the electrical socket.
6.Press the hot water switch (back of unit) to the ON position, the switch should be lit.
A. Press the cold water switch (back of unit) to the ON position, the switch should be lit.
B. Wait for the hot water to reach temperature in approximately 10 minutes C. Wait for the cold to reach temperature in other 40 minutes approximately.
7.Press the hot and cold water switch to turn them OFF and unplug the dispenser from the electrical outlet.
8.Drain the water by pressing hot water button and then cold water button, until no more water remains (to facilitate this operation, use a large container).
9.Drain any water left in the tanks by opening the drain cap located on the back side of the dispenser, until the water drains completely. Please remember to close the drain cap firmly after the drainage.
10.Place a 5 gallon or 3 gallon bottle of water onto the water intake of the dispenser; allow water to stand for approximate one minute.
11.Push water faucet buttons to insure water flows from both faucets.
12.Plug the dispenser into the electrical socket.
13.Now you are ready to use your water dispenser.
7
