Haier WQP4-1A manual Troubleshooting And Maintenance Service

Models: WQP4-1A

1 18
Download 18 pages 27.89 Kb
Page 15
Image 15
* Turn off the power switch. Operate it when power resumes.

TROUBLESHOOTING AND MAINTENANCE SERVICE

Power failure, ice up or water failure

Power failure

* Turn off the power switch. Operate it when power resumes.

 

 

 

* Fill warm water (below 31-70°C)to melt the ice.

Ice up

If the hot water pipe and the draining hose are frozen, melt them with warm water.

 

After ice melts, select "prewash"program to make an operation to make sure it is OK.

 

 

 

* If water fails during operation. Cut off the power to stop operation.

Water failure

When water comes again, restart the machine.

Select "prewash"program to drain out dirty water.

 

 

Then begin to wash.

 

 

Under following situation

1)Shut off the power, make a check and take measures as described in the follows:

2)Make a test run after faults have been eliminated.

3)When the above phenomena appear again, take off the plug and contact one of the maintenance departments.

Disorder

Possible causes

Measures to be taken

 

 

 

 

* Power failure.

* Take actions according to the above-mentioned

 

measures incase power failure.

No action

* The fuse in the inhouse switch box is burned.

* Change fuse.

at all

* The power plug is not inserted firmly.

* Insert the plug completely.

 

* The power switch is at "off" position.

 

* Set the switch at"on"position.

 

* The lock is at "open" position.

 

* Set the lock at "close"position.

 

* Program selecting button are not pressed.

 

* Press to confirm.

 

 

Abnormal

* The dishwasher is tilted.

* Level the unit.

sounds

* Chopsticks might block the sprayer.

* Rearrange them.

 

* The sound of spraying water striking the washing box is not

 

 

abnormal.

 

 

 

 

Water leaks

* Foreign substance is jammed between the door and the wa-

* Remove it and adjust it.

at the door

shing box.

 

 

 

 

 

* The draining hose is sunk.

 

No water is

* Ice up.

* Make it to normal condition.

* The middle part or the end of the draining hose is protruded

* Do as mentioned above for "ice up".

drained out.

too high.

 

 

 

 

* It is not abnormal that little water remains in the washing

* The protruding partsshould be less than 10cm.

 

box after operation.

 

GB

KNQK

Page 15
Image 15
Haier WQP4-1A manual Troubleshooting And Maintenance Service, Turn off the power switch. Operate it when power resumes