Troubleshooting
POSSIBLE PROBLEM
Machine will not work when switched “ON.”
Motor appears to stall when juicing.
Excess pulp building up in the Micro Mesh Filter Basket.
Pulp is too wet and insufficient juice is produced.
Juice leaks between the rim of the Juicer Cover and the Filter Bowl.
Juice sprays out of spout.
Juice drips out of spout immediately after juicing.
Machine vibrates excessively.
EASY SOLUTION
The Safety Locking Arm may not be correctly engaged. Check to see if Safety Locking Arm is properly positioned in the two grooves on either side of the Juice Cover. Refer to pages 5 and 6, Steps 4 and 5.
Wet pulp can build up under the Juicer Cover if the juicing action is too vigorous. Try slower juicing action by pushing the Food Pusher down more slowly. Refer to page 7, Step 4.
Turn OFF and unplug. Remove the Juicer Cover, scrape off pulp. Reassemble and begin juicing again. Try alternating vegetable and fruit varieties.
Try a slower juicing action. Turn OFF and unplug. Remove Filter Basket and clean mesh walls with a fine brush. This will remove excess fiber
Try a slower juicing action by pushing the Food Pusher down more slowly. Refer to page 7, Step 4.
Try a slower juicing action by pushing the Food Pusher down more slowly. Refer to page 7, Step 4.
With motor ON, raise and lower Food Pusher in Feed Chute several times. The pressure forces remaining pulp and juice out of Filter Bowl.
Build up of pulp in mesh of FIlter Basket. Turn unit OFF and unplug. Clean Filter Basket. Refer to page 10.
11