MAINTENANCE
FRONT DOOR GASKET
Front Door Handle Shown
If position of bracketry needs to be changed after adjustment:
If the front door gasket requires replacement 5/8" diameter material must be used. Hampton uses a 5/8" diameter gasket (Part#
The bracketryshouldstartfromthehighest point, as seen below. If needed, bring the bracketry down 1/16" each time, until fi nding the best locking position. The door latch will catch best in this way.
(Listen for a double click sound when the door is locked).
| Secure using 7/16" |
| socket wrench. |
HANDLE | LATCH ADJUSTMENT |
REPLACEMENT | METHOD |
Bracketry at
highest position
1)Remove handle (front or side) by undoing the hex head bolt using a 7/16" socket wrench.
2)Fit new door handle over latch and se- cure.
Assembly shown below.
Spacer
Handle
Hex Head
LockBolt
Washer
The door bracketry may require adjustment as the door gasket material compresses after a few
fires. Removal of the spacer washer will allow the latch to be moved closer to the door frame, causing a tighter seal.
Relocate the washer removed from the back of the bracket to the front. This will allow the same screw to be used.
Use the 3/16" allen key enclosed in the packaged manual to make this adjustment.
Front of Bracket
Remove spacer washers
behind screws.
Allen Key
Front of
Bracket
Hampton H200 Cast Freestanding Woodstove | 25 |
