Hampton H200 Cast Freestanding Woodstove
6
INSTALLATION
PRE-INSTALLATION ASSEMBLY
After removing the stove from its packing, open
the front door and remove the contents from the
fi rebox, leaving the bricks in place.

Rotating Elbow

This stove can be connected to either a top or
rear vent exit by simply reversing the orientation
of the elbow.
Simply remove the 2 screws, change the position
of the elbow as desired and secure in place
with screws.

Rear Heat Shield

(Used only on Vertical Installations)
1) Loosen the bolts that secure the elbow to
the unit. Ensure elbow does not fall off.
2) Bend the tabs on the rear heat shield inwards
90 degrees.
Rear Heat Shield
Slide tabs in between
washer and bolt.
3) Slide the tabs on the rear heat shield in
between the bolt and washer.
Bend tabs inwards 90 degrees.
4) Once rear heat shield is evenly in place,
tighten bolts to secure.
Please Note: The shield needs to be stretched/
fl exed in order to fi t in place.
Bolt Washer Handle
Draft Control Lever

Draft Control

Lever Handle

1) Insert bolt and lock washer through draft
control lever hole.
2) Place handle through bolt. Tighten to se-
cure.