Hampton H200 Cast Freestanding Woodstove
18

CAUTION: Label all wires

prior to disconnection

when servicing controls.

Wiring errors can cause

improper and dangerous

operation.

WARNING: Electrical Grounding

Instructions

This appliance is equipped with

a three pronged (grounding) plug

for your protection against shock

hazard and should be plugged

directly into a properly grounded

three-prong receptacle. Do not cut

or remove the grounding prong

from this plug.

An optional blower is available for the Hampton
H200. The blower is factory assembled, wired
and ready for attachment to the stove.
This unit must be connected to a grounded,
standard 120 volts, 60 Hz electrical outlet.
Never route the power cord under or in front
of the unit.
Do not under any circumstances, cut or remove
the grounding prong from the power cord. Do
not use an adaptor plug.
CAUTION: Moving parts may cause injury.
Do not operate unit with blower housing
removed.
DANGER: Risk of electric shock. Discon-
nect power before servicing unit.
NOTE: For more detailed information see
instructions included with the Optional
Blower.
OPTIONAL BLOWER/FAN INSTALLATION
Ground
Fan Fan
Ground Green
Neutral
Live
White
Fan
Switch
Manual/
Auto
Switch
Black Black
High(Black)
Low(Red)
Black
FanThermodisc
(normallyopen)
120VAC
60Hz
Blower/Fan Wiring Diagram
NOTE INPUT POWER: Australia, New Zealand,
China and Japan use 240V AC 50 Hz.
INSTALLATION
1) Remove fan cover plate from back shield
by undoing 3 screws and discard plate.
2) Remove back shield by undoing 2 bolts.
3) Loosen the 2 bolts you see after remov-
ing back shield, one on each side of the
stove.
4) Hook fan over the bolts.

Fan

5) Tighten bolts to secure fan.
Tighten
bolts
6) Re-install back shield.

Back

Shield

7) Using the 3 screws from the fan cover
plate, secure the fan assembly to the back
shield.
8) Plug in power cord.