INSTALLATION
OPTIONAL BAY DOOR
Removing Bay Door | BAY LOUVERS |
|
The Bay louvers MUST be used
with the Bay glass option.
The optional Bay door is an overlay on the flush front. The standard flush door and glass must remain on the unit. Hook the top of the bay door over the flush door flange and swing the bottom against the bottom flange of the flush door. Press down on the Bay Bottom bracket and push in until it clips behind the bottom of the flush front.
To remove only the Bay Door - use a screw- driver to unclip the Bay Bottom bracket from the flush door and then swing up and unhook from the top flush door flange.
To remove the Bay Door & the Flush Front together, pull the hook from the slot in the bottom door bracket under the unit (see Stand- ard Flush Door instructions above). Then pull the Bay Door and Flush door out and lift off of the flange at the top of the unit.
Note: If any maintenance etc. must be done in the firebox, first remove the Bay louvers and door.
1)Install top louver by sliding the two bracket clips into the brackets located on top of the bay door. See below. The fitted louver leaves a small gap between faceplate bot- tom and louver top.
Slide the valve extension knobs onto the valve knobs. Match each extension knob with the corresponding valve knob. Extension knobs are for Bay Front installations only.
Robert Shaw Extension knobs for Bay Front only.
OPTIONAL BAY TRIM
Attach 4 supplied magnets each to the back of the top and bottom trim pieces, and attach trim to the top and bottom of Bay door.
2) Install bottom louver by sliding the two bracket clips into the brackets located un- derneath the bay door. Secure with 1 screw into each Bottom Louver Mounting Bracket as per diagram below. Use the bottom hole in the bracket.
3) Slide the Robert Shaw valve extension knobs onto the valve knobs. Match the correct ext. knob with the valve knob.
12 |
