Bolts
(35)
Motor
Bracket
(36)
Spindle
Pulley
(38)
Bolts
(35)
Belt (34)
Motor
Pulley
(3e)
Figure 28
5.Remove the old Belt (34) and place a new belt on the Pulleys (3e and 38).
6.If the tension needs adjusting:
a.Loosen the four hex head Bolts (35) on the Motor Bracket (36).
b.Slide the bracket up or down until the sides of the belt are tight.
c.Tighten the bolts and make sure the belt runs straight.
NOTE: Never
7.Replace the belt guard and turn the machine right side up.
Carbon Brush Replacement
Replacement Carbon Brushes (3b) are included with this unit. The Carbon Brushes should be replaced by a qualified technician.
REV 10e |
|
|
SKU 32650 | For technical questions, please call | Page 21 |
