Instructions for putting
into use
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Assembly/Mounting
Protective foam sheet | Fence (2) |
Knobs
(4)
Figure 2
The Shaper/Router is packaged with a protective foam sheet covering the table top and the fence, secured in place on the table. Remove the Shaper/Router from the box then unthread the Knobs
(4)holding the Half and Long Fence (2a and 2b) pieces from the Table Top (7). Discard the foam sheet.
REV 10e
Mounting
Mount the Shaper/Router to a permanent location such as a work bench, or to a portable plywood base. If mounting to plywood, use a good grade of plywood or chipboard at least 3/4” thick.
|
| |
| 2” | |
| 2” |
|
11/16” | 11/16” | Diameter holes |
|
| Four 5/16” |
9- | 5- |
|
Base of Shaper/Router | Plywood or workbench |
|
Figure 3
To Mount the Shaper/Router, use the above dimensions to mark the drilling locations on the plywood or workbench, allowing at least 2” of clearance on all sides. Drill four 5/16” diameter holes and attach the Shaper/Router using grade 5 or better 1/4” bolts, flat washers and self locking nuts (sold separately). Be sure to purchase bolts which are long enough to reach through the Shaper/Router Base, the thickness of the Plywood
or workbench top, and allow for the washers and nuts.
WARNING: If you mount the Shaper/Router on a portable base, before each use, clamp the board securely to a workbench or supporting surface.
Installing the Height Knob
The Stud (17) for the Height Knob (16) is located on the back of the Base (25) and is packaged with a Nut (56) and Washer (18).
SKU 32650 | For technical questions, please call | Page 9 |
