Grounding Instructions

To prevent electric shock

and death from incorrect grounding wire connection

Read and follow these instructions:

3-pole receptacles that accept the tool’s plug.

6.Repair or replace damaged or worn cord immediately.

110-120 V~ Grounded Tools: Tools

with Three Prong Plugs

Grounding

Pin

1.In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This tool is equipped with an electric cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into a matching outlet that is properly installed and grounded in accordance with all local codes and ordinances.

2.Do not modify the plug provided – if it will not fit the outlet, have the proper outlet installed by a qualified electrician.

3.Improper connection of the equipment- grounding conductor can result in a risk of electric shock. The conductor with insulation having an outer surface that is green with or without yellow stripes is the equipment-grounding conductor. If repair or replacement of the electric cord or plug is necessary, do not connect the equipment-grounding conductor to a live terminal.

4.Check with a qualified electrician or service personnel if the grounding instructions are not completely understood, or if in doubt as to whether the tool is properly grounded.

5.Use only 3-wire extension cords that

have 3-prong grounding plugs and

REV 10e

125 V~ 3-Prong Plug and Outlet

(for up to 125 V~ and up to 15 A)

7.This tool is intended for use on a circuit that has an outlet that looks like the one illustrated above in 125 V~ 3-Prong Plug and Outlet. The tool has a grounding plug that looks like the plug illustrated above in 125 V~ 3-Prong Plug and Outlet.

8.The outlet must be properly installed and grounded in accordance with all codes and ordinances.

9.Do not use an adapter to connect this tool to a different outlet.

Shaper Safety Warnings

For Your Own Safety Read Instruction

Manual Before Operating Shaper

1.Wear eye protection.

2.Be sure keyed washer is directly under spindle nut and spindle nut is tight.

3.Feed work piece against rotation of cutter.

4.Do not use awkward hand positions.

5.Keep fingers away from revolving cutter

– use fixtures when necessary.

SKU 32650

For technical questions, please call 1-800-444-3353.

Page 5

Page 5
Image 5
Harbor Freight Tools 32650 Grounding Instructions, 110-120 V~ Grounded Tools Tools With Three Prong Plugs