Unpacking
When unpacking, check to make sure all of the parts listed on the parts list on page 7 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual.
Assembly
The only assembly required is the addition of the Adjustment Screw (#6) and Safety Ring (#20).
1.Insert the Adjustment Screw (6) with the Hex Nut up, through the hole in the center of the Plain Axle (13).
2.Add (by sliding on) the Safety Ring (20) to the Adjustment Screw (6) before continuing through the center hole on the Threaded Axle (10).
3.Secure Adjustment Screw (6) with two Nuts (15).
Operation
Warning: MacPherson struts must be removed from the vehicle before attempt- ing repairs. Make sure to put the struts in a MacPherson Strut Vise prior to using the Strut Spring Compressor.
Warning: Only use hand tools with the Strut Spring Compressor. Never use any air, electric, or impact tools with this tool. Only operate this tool with a 3/4”socket and ratchet, 3/4” combination wrench, or other applicable hand tool. Power, air, or electric tools may compress the spring, leading to injury.
Note: The Strut Spring Compressor should be periodically inspected by a qualified service technician.
Removing a MacPherson Strut from a vehicle.
1.Position the strut into a strut vise.
2.Shut the vise and tighten.
Attaching the Spring Compressor
3.Open the Spring Compressor approximately 8 inches. Do not open more than 8” or a long strut may slip off of the tool.
4.Make sure the hex nut on top of the Adjustment Screw (#6) is facing up.
5.Before clamping the spring, slip the Safety Block (#19) over the Hook (#5) and Hook (#7) as a safety precaution should the strut break loose.
Figure 1
8” Max.
Center Axis
REV 01e, 08l
SKU 43753 | For technical questions, please call | Page 4 |
