
Replace the lower handrail clamp and secure the handrails to the clamp using two socket head screws (E) and two washers (F).
Replace the four lower handrail clamp fasteners removed in step 8. To reduce gaps between the upper and lower portions, squeeze the clamp together while you wrench tighten all six fasteners.
Test the heart rate feature.
a.Turn the unit ON. The Precor banner appears in the display.
CAUTION: When testing the heart rate feature, stand to the side of the treadmill until the lift stops moving and the incline returns to zero.
b.Face the display and straddle the running belt.
c.Place both hands on the
d.When the test is completed, turn the treadmill OFF and continue with step 16.
Note: If the blinking Hr does not appear, turn the unit OFF. Recheck the cable connections beneath the handrail clamp and ask someone else to test the heart rate feature.
Tighten the following mounting screws.
a.Wrench tighten the two upper handrail side screws. Refer to step 9.
b.Wrench tighten the four side rail screws at the base of the handrails. Refer to step 10.
Level the unit by inserting the
Important: Do not raise or lower the unit beyond 2 centimeters (¾ inch). Check the level of the unit after each adjustment. Place a bubble level across the rear deck for precise measurements.
Check the alignment and adjust the running belt. For instructions, refer to Checking the Alignment and Adjusting the Running Belt.
M9.3xi | 6 |