Use the
Note: In steps 9 and 10, wrench tighten each fastener until the head is flush against the assembled part and then reverse the motion to loosen the fasteners by one or two full turns. Some movement in the handrails is necessary to allow for proper alignment of the assembly.
Slide the ends of the handrails toward the center handrail clamp and secure them to each side bracket using two socket head screws (C) and two washers (F). Make sure the black foam on the handrail does not cover or interfere with the handrail clamp mounting holes.
Attach the lower portion of the handrails to the side rails using four socket head screws (C) and four washers (D). Refer to the note above.
Heart rate cables protrude from the ends of both handrails. Slide the end of each cable into its receptacle. Carefully place excess cable inside the recessed area in the display console.
Important: The cable receptacles mirror the connectors so that they cannot be improperly installed. Do not force a connection! Take your time and look for the tabs on the connectors.
CAUTION: Do not place the excess cable in the handrails.
The handrail clamp fasteners can damage the cable.
Make sure the excess heart rate cables are not impeding the function of the safety switch. Pull on the safety lanyard. If the red STOP button depresses and you hear a clicking sound, the safety switch is working properly.
M9.3xi | 5 |
