During the program, the TIME display relates to the amount of time remaining in the recorded columns. Total elapsed time appears when you record new columns.

Note: The length of the custom program and the number of speed and incline settings is limited to available memory in the treadmill. The program will not end if the available memory is exhausted, but the display notifies you and further changes to speed or incline are not saved. Approximately 1¹⁄₂ hours of recording time is available.

Clearing the Settings in a Custom Program

Perform the following steps to clear (delete) any speed and incline settings stored in a custom program.

1.At the Precor banner, select a user ID, and then press

ENTER.

2.Display the custom program that you wish to clear.

Important: Clearing the speed and incline settings from a custom program permanently deletes them from memory.

3.While the custom program name appears on the display, hold the red STOP button for about fourteen seconds. After the CLEARED message appears on the display, you can release the key. Speed and incline information are reset to zero.

Note: During the 14-second delay and before the CLEARED message appears, you can release the red STOP button and no change will occur to the custom program settings.

Owner’s Manual: Programs

37

Page 39
Image 39
Precor M9.35I manual Clearing the Settings in a Custom Program