Precor M9.35I manual Assembly Steps

Assembly Steps

Use a ¼-inch hex key and ½-inch box end wrench to remove the four shipping fasteners on the front panel. Discard the fasteners.

Place the left side upright into the base frame side bracket. Secure the upright to the front panel using two socket head screws (C). Secure the upright to the side bracket using two socket head screws (A), two washers (D), and two barrel spacers (B). Wrench tighten.

Unwrap the cable and feed it through the right side upright. Tape the cable along the front edge of the upright.

CAUTION: Before attaching the display console, make sure the cable is taped along the front edge of the upright.

Place the right side upright into the base frame side bracket. Secure the upright to the front panel using two socket head screws (C). Secure the upright to the side bracket using two socket head screws (A), two washers (D), and two barrel spacers (B). Wrench tighten.

Important: Do not stretch, crimp, or damage the cable. Cables damaged by improper installation will not be covered by the Precor Limited Warranty.

M9.3xi Low-Impact Treadmills Assembly Guide 3