Selecting a U.S. Standard or Metric Display
The treadmill can display measurements in either U.S. Standard or Metric. When the treadmill is shipped from the factory it is set to display U.S. Standard. To change this setting, perform the following steps:
1.At the Precor banner, press the following keys in sequence and without pause:
Treadmill | Key Sequence |
|
|
M9.35i | STOP, 5, 6, 7, 1 |
|
|
M9.33i | STOP, SPEED ▼, SPEED ▲, ENTER, |
| PROGRAMS |
|
|
The numbers 5, 6, 7, 1 appear on the display as you press the associated key.
2.SELECT UNITS appears, followed by the current unit of measure. Use an arrow key to switch between the options.
3.Press ENTER to accept the displayed setting.
The change will be retained in memory even if the treadmill is turned OFF and unplugged.
4.To continue programming the treadmill to change password protection, refer to Selecting Password Protection.
5.If you want to end programming, press STOP.
Owner’s Manual: Advanced Programming and Troubleshooting | 52 |
