ty of operation. Observe thread direction of the bolt.
9.Causes and Operator Prevention of Kickback:
•Kickback is a sudden reaction to a pinched, bound or misaligned saw blade, causing an uncontrolled saw to lift up and out of the workpiece toward the operator;
•When the blade is pinched or bound tightly by the kerf closing down, the blade stalls and the motor reaction drives the unit rapidly back toward the operator;
•If the blade becomes twisted or mis- aligned in the cut, the teeth at the back edge of the blade can dig into the top surface of the wood causing the blade to climb out of the kerf and jump back toward the operator.
Kickback is the result of saw misuse and/or incorrect operating procedures or conditions and can be avoided by taking proper precautions as given below:
a.Maintain a firm grip with both hands on the saw and position your arms to resist kickback forces. Position your body to either side of the blade, but not in line with the blade. Kickback could cause the saw to jump backwards, but kickback forces can be controlled by the operator, if proper precautions are taken.
b.When blade is binding, or when inter- rupting a cut for any reason, release the trigger and hold the saw motion- less in the material until the blade comes to a complete stop. Never attempt to remove the saw from the work or pull the saw backward while the blade is in motion or kickback may occur. Investigate and take cor-
rective actions to eliminate the cause of blade binding.
c. When restarting a saw in the work- piece, center the saw blade in the cut and check that saw teeth are not en- gaged into the material. If saw blade is binding, it may walk up or kickback from the workpiece as the saw is restarted.
d.Support large panels to minimize the risk of blade pinching and kickback. Large panels tend to sag under their own weight. Supports must be placed under the panel on both sides, near the line of cut and near the edge of the panel.
e.Do not use dull or damaged blades. Unsharpened or improperly set blades produce narrow kerf causing excessive friction, blade binding and kickback.
f. Blade depth and bevel adjusting lock- ing levers must be tight and secure before making cut. If blade adjustment shifts while cutting, it may cause binding and kickback.
g.Use extra caution when making a ″plunge cut″ into existing walls or other blind areas. The protruding blade may cut objects that can cause kickback.
10.Check Lower Guard (A7) on Circular Saw for proper closing before each use. Do not operate the saw if Lower Guard does not move freely and close instantly. Never clamp or tie the Lower Guard into the open position. If saw is accidentally dropped, Lower Guard may be bent. Raise the Lower Guard with the retracting handle and make sure it moves freely and does not touch the blade or any other part, in all angles and depths of cut.
11.Check the operation of the Lower Guard (A7) spring on the Circular Saw. If the Guard and the spring are not operating properly, they must
Page 6 | For technical questions, please call | SKU 66755 |
