Use
4.Pick up the Spray Gun (2A) and point it away from you. Squeeze the Trigger Handle until all internal air is released, and a steady flow of water comes out. Release the
Trigger Handle.
5.Move the Choke Lever (C) to the closed (left) position. See engine photo below.
6.Turn the Fuel Valve (D) to the open (down) position.
7.Move the Throttle Control Lever (E) 1/3 to the left.
8.Turn the red Power Switch (F) to the ON position.
Gasoline Tank (B)
Throttle Control Lever (E) Choke Lever (C)
Fuel Valve (D)
Starting Handle (G)
Power Switch (F)
9.Pull the Starting Handle (G) lightly until you feel resistance. Then, pull it completely out. The engine should start up. Slowly release the Starting Handle. Make sure the Pressure Washer is on a level surface so it does not roll.
10.Adjust the Throttle Control Lever (E) for the desired speed and subsequent output water pressure. Open the Choke Lever (C) to the right.
If the engine does not start after a few tries, refer to Troubleshooting Tips on the next page.
11.Hold the Spray Gun (2A) with both hands and begin spraying.
Do not allow the engine to run for more the three minutes without spraying. Adjust the Spray Gun Nozzle (13A) to the desired spray pattern.
SKU 91142 | For technical questions, please call | Page |
